Articles, Blog

Trailer Hitch Installation – 2008 Jeep Commander – Draw-Tite – etrailer.com

Trailer Hitch Installation – 2008 Jeep Commander – Draw-Tite – etrailer.com


Today on our 2008 Jeep commander well be installing
hidden hitch, part number 87752. This is what our hitch will look like once
its installed. Next well go ahead and give you a couple of
measurements to assist you with selecting accessories for your new hitch. From the center of the hitch pin hole to the
outer most edge of the bumper is four inches. From the top of the receiver tube to the ground
is 17 and one-quarter inch. This will assist you with selecting accessories
such as a draw bar, a bike rack, or a cargo carrier. Now lets go ahead with installation. Note weve already gone ahead and lowered and
removed the spare tire for easier installation and access. Note we have a total of four attachment points
in the bumper beam pre-drilled by the manufacturer here. In order to get our hitch in place well need
to remove two of the plastic push pin fasteners located on the bottom side of the bumper beam. Using our flat bladed screwdriver well pry
the center of the plastic fastener out and then remove the fasteners.

Tagged , , , , , , , , , , , , , , , , , , , , , , ,

Leave a Reply

Your email address will not be published. Required fields are marked *